RaccouBass 0.9.1 VST

Warning!

The plugin's system requirements have increased significantly.

Minimum system requirements:

Processor: 1st generation AMD Ryzen 5 or equivalent Intel Core i5 processor.

Recommended system requirements:

AMD Ryzen 7 3rd generation or higher processor or equivalent processors.

Plugin for 64-bit version only

The plugin may contain errors, if you are working with the plugin and have problems, you can contact me.

What's New?

1. -Added new versions of the Oscillator.
2. -Added Pitch tune block (to all 4 oscillators).
3. -Added Step Sequenser (to all 4 oscillators).
4. -Added Smooth block (For sound attenuation) (on all 4 oscillators).
5. -Added Bit Crusher block for working with 8-bit audio (on all 4 oscillators).
6. -Added WaveShaper (Using it you can control the sound wave manually) (on all 4 oscillators).
7. -Added Chorus effect (to all 4 oscillators).
8. -Added Reverb effect (to all 4 oscillators).
9. -Added Phaser effect (to all 4 oscillators).
10. -Added two block menus for selecting effects (Effects, Experimental) (for all 4 oscillators).
11. -Added a General effects menu for all Oscillators. (Menu Main FX).
12. -Added knob Volume PM (to adjust the mix volume Phase Dist) (on all 4 oscillators).
13. -Added LFO Mod for sound modification + Attack,Decay,Sustain knobs (on all 4 oscillators).
14. -Added Preset Manager. You can create your own presets and Banks.
15. -Added 124 presets and divided into categories: Bass, Lead, Pad, Pluck, FX.
16. -Added menu choose a preset.
17. -Added a menu for selecting work with the plugin area.
18. -Added Swing knob module for wave shifting (on all 4 oscillators).
19. -Added polyphony control menus,polyfony Stealing,Polyfony reserve,Band Range,Legato,Voice Refresh.
20. -Added an osciloscope to view the phase of the sound wave(on all 4 oscillators).

What's Fixed?

1. -Volt Meter signal readings were displayed incorrectly.
2.  -Partial or incorrect work on Phase Dist notes creating a crooked sound and disrupting the tone.
3.  -The filter effect worked poorly and did not mute the sound properly.
4.  -The oscilloscope did not fully output the sound wave. Showed one phase of sound from above.
5.  -Phase Dist did not work correctly or crooked sounds were obtained and there was a problem with the effects of a note and the same frequency or tone.
6.  -The Overall knob was removed and did not work correctly.
7.  -Removed Mono Mode and Portamento due to problems with the MIDI signal module. It will be added in new updates.
8. -Changed plugin size.